![background image](http://html.mh-extra.com/html/sick/inspectorp631-c-mount/inspectorp631-c-mount_operating-instructions-manual_1264201017.webp)
Convenient functions such as function buttons, auto-setup, aiming laser, an acoustic
feedback signal, and a green feedback LED reduce the amount of work required for
training and installation.
The microSD memory card can be used to store images or backup copies of parame‐
ters. Thanks to SICK's 4Dpro feature, the InspectorP6xx can be integrated into numer‐
ous industrial networks.
3.3.4
Memory card
The device has a card slot integrated in the housing. The card slot accommodates a
memory card in microSD format.
NOTE
The microSD memory card is optional and not included in the scope of delivery of the
device. The device supports memory cards up to max. 32 GB.
Only use types (industrial standard) approved by SICK to ensure reliable function of the
memory card. You can find these as accessories online at:
•
The memory card has no write protection that can be activated.
Inserting the memory card in the device:
NOTICE
Risk of damage to the memory card!
b
To avoid damaging the microSD memory card, make sure the device is
de-ener‐
gized
when you insert or remove the card. For this purpose, disconnect the device
from the supply voltage.
Access to the card slot
The card slot for the memory card is located under the hinged cover on the top side of
the device.
1.
Switch off the supply voltage to the device.
2.
Undo the screws (SW2 hexagon key) on the hinged cover and open the cover as
follows:
°
Carefully pull the upper edge of the cover away from the housing a little at the
level of the hinges on the side. Use both of the recesses on the inside of the
cover to do this.
°
Fold the cover upwards starting from the bottom edge.
3.
Making sure it is in the correct position, insert the memory card into the slot until
it locks into place. When doing this, position the contacts so that they are facing to
the rear and upwards, see the card symbol on the device.
4.
Close the hinged cover. Make sure that the cover is completely flush with the
housing.
5.
Tighten the screws on the hinged cover again.
6.
Switch on the supply voltage for the device.
PRODUCT DESCRIPTION
3
8019946/1EJ6/2022-02 | SICK
O P E R A T I N G I N S T R U C T I O N S | InspectorP63x Flex C-mount and S-mount
17
Subject to change without notice