3 D D R I V E R A S S I S TA N C E S Y S T E M | 3 V I S T O R - P
8018167 / 2015-03-31 | S I C K A G
Subject to change without notice
5 7
MOUNTING
4. Prepare the mounting location for the EU (2) inside the driver's cab by making
holes for the brackets and installing cable conduits for the feed cables.
NOTE!
Sufficient free space is required around the EU (approx. 10 cm) to allow heat dissipa
-
tion. Choose the mounting location accordingly.
Make sure there is no risk of the EU getting covered during operation (e.g., by jackets,
blankets, and so on).
5. Attach the bracket for the display inside the driver's cab (1).
5.7
Mounting
5.7.1
Mounting the sensor head
1. Mount the two U-shaped holders on the prepared support one after the other.
Make sure that you mount the bottom U-shaped holder first.
2. Carefully insert the sensor head into the top U-shaped holder.
3. Fix the sensor head in place using the screws at the sides.
4.
Adjust the installation angle of the sensor head and fix it in place with the two rear
screws.
5.
Place the sensor head cover over the top U-shaped holder and firmly tighten the
screws.
5.7.2
Mounting the EU
1. Screw the mounting brackets onto the EU.
2. Attach the EU and mounting brackets to the location that you prepared inside the
driver's cab.
5.7.3
Mounting the display
b
Carefully insert the display into the pre-assembled bracket.
