- 11 -
z
If the hinges are not fully inserted, it may not be possible to fasten the snap fastener.
z
Handle the detachable hinges carefully. It may not be possible to attach the canopy if
the hinges become damaged.
Assembly and Installation Procedure
Be sure to move the product disassembled into three sections.
Install the product on a flat surface. Avoid high moisture, high humidity sites, sites in proximity
to flames or heat sources, and extremely dusty sites.
1. Place the folding stand in position.
With the bracket backstop oriented toward the back, unfold
the stand until the wires are taut and then spread open the
brackets slightly.
2. Place the main unit on the folding stand.
Lift the main unit by holding the handles. Slide the back
side of the main unit against the bracket backstop, so that
it is distributed equally on the left and right brackets.
z
If it is only supported by one bracket, remove the main
unit and start over from the point of spreading open the
brackets.
z
The main unit is tightly pinched between the brackets,
so place a foot on a bottom bar, for example, before
removing the main unit.
3. Install the canopy.
The hinges can only be attached or detached when the canopy is in a position partially open
and closed. Attach the canopy by holding it at an angle and sliding the left and right
detachable hinges all the way toward the back.
Can be attached/detached
Cannot be
attached/detached
