siat ProWrap 16_H_FM, Operation And Maintenance Manual

Page: 20 / 104

Technical Specifications
IDM 510-129-1
18
English language Operation and maintenance manual
Types of wrapping
The wrapping can be made in manual or automatic mode.
– With the manual mode, platform rotates at a reduced speed, while reel holding
carriage is activated by a non-release control.
This mode allows for the wrapping to be made on an occasional basis, according
to the specifications of the load to be wrapped (See “Control system.”).
– With the manual mode the wrapping can be programmed according to the spec-
ifications of the load batch to be wrapped.
– The figures show the types of wrapping that can be programmed with the auto-
matic mode operation.
– Single wrapping: it starts at the base of the load to be wrapped
(with stabilisation wraps) and ends at the top of the load, after
completing the closing wrapping.
– Move the reel carriage to fully lowered position from the control
panel to start a new wrapping.
The operator can decide whether to cut the film when the car-
riage is in the high position or in the low position.
– Double wrapping: it starts at the base of the load to be
wrapped (with stabilisation wraps) and ends at the top of the
load.
– After completing the reinforcement at the top of the load, the
wrapping continues downwards and stops after the closing
wrapping.
– Single wrapping with sheet feeder: it starts at the base of the
load to be wrapped (with stabilisation wraps) and stops tempo-
rarily at the top of the load.
– After inserting the covering sheet the operator must enable the
control to restart the wrapping.
– After completing the upper reinforcement, the wrapping stops.
– Move the reel carriage to fully lowered position from the control
panel to start a new wrapping.
The operator can decide whether to cut the film when the car-
riage is in the high position or in the low position.
– Double wrapping with sheet feeder: it starts at the base of
the load to be wrapped (with stabilisation wraps) and stops
temporarily at the top of the load.
– After inserting the covering sheet the operator must enable the
control to restart the wrapping.
– After completing the reinforcement at the top of the load, the
wrapping continues downwards and stops after the closing
wrapping.