60
loss of information caused by mishandling of the level transmitter;
a malfunction of the level transmitter itself.
The inscription that appears on the display indicates the type of fault.
A list of possible faults is described in Supplement 11.
Supplement 11.1. Restarting the level gauge
Press the MODE and LEVEL buttons simultaneously to restart the
level gauge. The message is displayed for 1 second:
СУДОС
Then the level gauge is set to the borehole pressure monitoring
mode.
Supplement 11.2. Recorded echogram test
The recorded echogram test is activated by simultaneously pressing
the MODE, INPUT-OUTPUT, LEVEL buttons and releasing the LEVEL
button. The message is displayed for 1 second:
СЕРВИС
The level gauge then performs a direct test of the recorded character
and echogram reports. The test can take up to 30 seconds.
The time to complete the test depends on the number of echograms
recorded after the transmitter is initialized. Upon successful completion
of the test, the device will enter Annular Pressure Monitor mode and will
not shut off after a 100 second delay from the last press of any button.
To reset the 100 second delay function, turn the gauge off and on again.
Supplement 12. Malfunctions detected by testing the level gauge
During the testing of the level gauge (Supplement 11), there can be
identified the following failures which are not cause the transmitter to
malfunction and allow you to work with the device:
:
Summary of Contents for SUDOS-mini 2
