Si-tex SAS-300, Operation Manual

Page: 82 / 104

- 75 -
Installation
Connection to a PC or Mac
If you choose to use a PC or Mac with suitable charting software to display received AIS messages as
other vessels, this can be accomplished by connecting the USB connector on the supplied power and
data cable.
3.2 Installation procedures
Before beginning installation of your AIS transceiver, please ensure you have the necessary additional
items as detailed in section 3.1. It is strongly recommended that you read all of the instructions in this
manual prior to installation.
If after reading this manual you are unsure about any element of the installation process please
contact your dealer for advice.
The following sections explain the installation process step by step for each of the main elements of
the system.
Step 1 - Installing the AIS transceiver
Please note the following guidelines when selecting a location for your AIS transceiver:
• The AIS transceiver must be fitted in a location where it is at least 0.2m from a compass or any
magnetic device.
• There should be adequate space around the AIS transceiver for routing of cables. See Figure 5 for
details of the AIS transceiver dimensions.
• The ambient temperature around the AIS transceiver should be maintained between -25°C and
+55°C.
• The AIS transceiver should not be located in a flammable or hazardous atmosphere such as in an
engine room or near to fuel tanks.
• The AIS transceiver is fully waterproof to ingress protection rating IPx7, however it is recommended
that the AIS transceiver is not subjected to extended periods of exposure to spray or submersion.
• It is recommended that the AIS transceiver is installed in a 'below decks' environment.
• It is acceptable to mount the AIS transceiver either vertically or horizontally.
• The product is supplied with four self tapping screws for attachment of the AIS transceiver to a
suitable surface. Please refer to Figure 6 for guidance.
• The AIS transceiver should be mounted in a location where the indicators are readily visible as these
provide important information on the status of the AIS transceiver.
• If the internal GPS antenna is used the AIS transceiver should be mounted in a location with a clear
sky view. The internal GPS antenna is mounted below the top surface of the transceiver enclosure.