Si-tex SAS-300, Operation Manual

Page: 28 / 104

- 21 -
Installation
SAS-300 brings expandable display technology to your bridge or navigation station. A careful
installation will assure maximum benefit from SAS-300 integrated features.
Display Unit Location
Select a location for your SAS-300 display unit that provides easy viewing from all likely operator’s
positions. The display unit is designed to be mounted on either a console or from an overhead surface.
The SAS-300 display is also designed for flush mounting using six threaded holes on the rear panel.
Locate the display in an area with protection from the elements and avoid direct sunlight on the
viewing window. Also, consider access to the rear panel of the unit for connecting power and cables to
the various remote sensors. The mounting surface must be flat and solid to support the unit and
prevent vibration. There should be access to the inside of the surface to permit through bolt fastening
for the mounting bracket.
Display Unit Installation
Temporarily install the mounting bracket on the Genesis display unit and place the unit at the selected
location.
CAUTION
The SAS-300 display unit is unstable when the mounting bracket is not secured. Hold the unit
in place at all times.
Check the suitability of the location and make any adjustments. When all is satisfactory, use the holes
in the mounting bracket as a guide and mark the holes locations on the mounting surface.