SHOWTEC eventbar 12/3, User Manual

Page: 19 / 32

18
Ordercode: 44110
EventBAR 12/3
Main Menu Options
Master/Slave Mode
DMX Mode
Static Color Mode
Power Mode
Settings
Auto Run
Built-in Programs
The EventBAR 12/3 will show its model number en software version number at start-up !
and
1. Master/Slave Mode
Master
01) The default setting for this device is master.
02) Only one fixture can be the master.
Note:
• Disconnect the fixture from the DMX controller before master/slave operating, otherwise data
collisions may occur and the fixtures will not work properly!
• In master/slave mode, the master fixture can execute the built-in programs, all the slave fixtures will
work the same.
• When operating the master/slave chain, you can identify the master fixture from the slave fixtures
easily. The master doesn’t have any cable plugged into the DMX input connector.
Slave control
This function allows you to control the slaves from the master’s control panel in a master/slave setup.
01)
Only 1 fixture can be the master, the others have to be Slaves. The Default setting for a device is
Master. So on the first device you don’t have to change anything.
On the slave devices you must press the MODE button until the display shows .
02) All slave devices must have address .