9
Order code: 34040
ACT Flood 80 RGBW
Installation
Remove all packing materials from the ACT Flood 80 RGBW. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120 V specification product on 230 V power, or vice versa.
Connect the device to the main power supply.
Multiple Fixtures Power Linking
The ACT Flood 80 RGBW supports power linking. Power can be relayed to another device via the power
OUT connector. Note that the input and the output connectors have different designs: one type cannot
be connected to the other.
To link fixtures in a chain, a hard usage cable with appropriate cable jacket must be used. Power linking
cables are available for purchase from Highlite International.
To prevent power overload and damage to the fixture, do not link more fixtures in one chain than
recommended. After you have reached the maximum number of fixtures, use a new power outlet.
Maximum recommended number of fixtures on a power link @ 110 V: 20 fixtures
Maximum recommended number of fixtures on a power link @ 240 V: 45 fixtures
