16
Order code: 34040
ACT Flood 80 RGBW
1.1 DMX Address
In this pop-up submenu you can set the starting DMX address of the device.
01)
Press the UP/DOWN buttons to select the starting DMX address of the device. The selection range is
between 1 and 512.
02)
Press the ENTER button to confirm the selection.
1.2 DMX Channel Mode
In this pop-up submenu you can select the DMX channel mode.
01)
Press the UP/DOWN buttons to select the desired DMX channel mode. There are 3 options available:
02)
Press the ENTER button to confirm the selection.
1.3 DMX Fail
In this pop-up submenu you can determine the behavior of the device in case of a DMX signal failure.
01)
Press the UP/DOWN buttons to select one of the following 3 options:
●
Manually Defined: The device will use the dimmer value selected with the manual color control
(4) and manual dimmer control (5) in manual mode. Refer to One ACT
Flood (Manual Control) on page 10 for more information
●
Hold:
The device will use the last properly received DMX signal
●
Blackout:
The device will black out the light output
02)
Press the ENTER button to confirm your choice.
