SHOWTEC 50405, Manual

Page: 22 / 32

21
Ordercode: 50405
RDM Commander
11. System Setup
With this menu you can set the device’s settings.
01) Select System Setup and open the menu. The display will show:
02) Select the desired menu and press the jog wheel to open.
11.1. DMX & RDM Settings
01) Select DMX&RDM Settings and press the jog wheel to open. The display will show:
02) Now you have the following options to choose from:
 TX Start Code: Set the starting value for DMX signal transmission. The adjustment range is
between 0-255. This option has influence on DMX Data--TX mode. See page 12.
 RX Start Code: It is set by default to 000. The adjustment range is between 0-255. If you choose
All , the device will be able to receive all kinds of signals.
 Max Level: Select Normal or Hold . If you have chosen Normal , the device will display all received
DMX data. If you have chosen Hold , the device will display only the highest value for each
channel.
 Auto Identify: Select ON or OFF . If you have chosen ON , the light effect will send identification
order to the device in DMX Tester function. If you have chosen OFF , the light effect will not send
any identification order.
 16bit: Select Coarse first or Fine first . You should choose a 16-bit light effect in Chase Mode and
Color Mode (see pages 14-15) for this function to work.
03)
Select the desired menu and press the jog wheel to open.
04) Select Confirm and press the jog wheel to save your changes.
11.2. Display Setting
01) Select Display Setting and press the jog wheel to open. The display will show:
02) Now you have the following options to choose from:
 Contrast Level: Set contrast. The adjustment range between 1-10, from low to high contrast.
 Backlight: Switch the backlight ON or OFF .
 Display: Set the display format (decimal, hexadecimal or percents).
03)
Select the desired menu and press the jog wheel to open.
04) Select Confirm and press the jog wheel to save your changes.