8
Multiple
Studiobeams Tour Q4 LED
(DMX Control
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Always use a safety cable (ordercode 70140 / 70141).
3.
Use a 3-p XLR cable to connect the LED Studiobeams and other devices.
4.
Link the units as shown in (figure 5), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit. Do
not supply power before the whole system is set up and connected properly.
Multiple LED Studiobeams DMX Set Up
Fig. 5
Note : Link all cables before connecting electric power
Summary of Contents for 42486
Page 19: ......
