Document Number: 0004593
Rev: 1
Page 15
Pair the Wireless Remotes with the ShoreStation Electric (EDS) Boat Lift
To pair with the system all remote controls used with the lift need to be available and unlocked. Make sure all wireless remotes are
in Mode #1. The lift must also be enabled by turning the lockout key to the ON position.
FlexPower Electric Lifts are placed into pairing mode by pressing the button on the back
of the controller mounted inside the winch system. To access the controller, the front
cover must be carefully removed. The pairing button is located on the back of the
controller (Figure 2). Press and hold the button until the controller beeps indicating it is
in pairing mode.
Make sure the wireless controller is in Mode #1. Press the ON (UP) button on each
wireless remote once to pair with the controller. The winch controller will beep each
time a remote button is pressed during pairing mode. A maximum of 5 remotes can be
paired at once.
Test the Wireless Operation
Test the operation of the wireless by switching to Mode #1 using the Select button. Test the boat lift operation. Switch to Mode #2
(using the Select button) and test the curtain operation.
Pairing Existing FlexPower Controls
This process pairs the controls that came with your ShoreStation FlexPower Hydraulic or Electric boat lift. In this case, we will unlock
the Mode 2 of your boat lift’s wireless controllers and initiate the pairing process on the ShoreScreen’s controller (Figure 3).
Use the following steps to unlock the correct mode and pair with the ShoreScreen:
Figure 3 - ShoreScreen Control Location
Figure 2 - FlexPower Electric (EDS) Pairing
Button Location
