DETAIL A
A
Proper Cable Adjustment
a) There are four cables with Eye Bolts and nuts that must be adjusted to properly level cables.
These Eye Bolts are all located near the rear uprights as shown.
b) Turn wheel so front rack beam raises about 6" above the bottom of frame. Adjust cables so
all corners of rack are the same distance from frame.
Note:
Adjust the cable length by turning the nut on top of the Eye Bolt. Hold the Eye Bolt stationary
while adjusting the top nut. Using the frame below the rack as your reference point, measure the
distance from frame to rack in each corner. These distances should all be within a 1/4 inch.
Note:
Be sure washer is in place and that Nyloc Nut is tightened so at least 1/4" of Eye Bolt thread
is exposed.
3/4" is a good starting point for leveling the Rack.
6"
1/4"
Nut
Washer
Eye Bolt
Eye Bolts
