{7}
Shor-Line | 800.444.1579 |
www.shor-line.com
;
Section 3: Warming Pad Assembly
{Assembly}
A minimal amount of assembly is required before using
your new Warming Pad. The Warming Pad is connected to
the control box using a 24” armored cable. The cable comes
factory installed on the Warming Pad and should not be
removed. See Fig. 3.1
Shor-Line Warming Pad Systems provide a warm
temperature-controlled bedding surface for small animals or
to assist in post-operative recovery. A towel may be placed
between the warming pad and the patient. Turn animals
routinely. Fractious animals should not be allowed access to
the Warming Pad without careful supervision because the
Warming Pad could be damaged.
The Warming Pad can be used by placing the unit under the
patient while lying on a table or placed inside a
Shor-Line 24 x 24
"
or larger cage.
NOTICE:
Improper cable connections can cause product
malfunction. Failure to follow proper connection procedures
may result in a void of all Shor-Line warranties.
{Placing Unit in Cage}
Step 1
Ensure that the Warming Pad is not
connected to the controller.
Step 2
Place Warming Pad inside cage.
Step 3
Feed cable through the rods at the bottom left hand side of
the cage door. See Figure 3.2.
You are now ready to install the controller.
Fig. 3.2
ARMORED CABLE
WARMING PAD
DO NOT REMOVE
CABLE FROM PAD
Fig. 3.1
