-30-
Model W1825 (For Machines Mfd. Since 07/15)
SE
TU
P
Figure
43
. Example of fence square with
miter slot.
Figure
42
. Four fence cap screws.
Aligning.Fence
To ensure cutting accuracy when the fence is first
installed, the fence should be aligned with the miter slot.
To.align.the.fence.parallel.with.the.miter.slot,.do.these.
steps:
1..
DISCONNECT BANDSAW FROM POWER!
2.
Make sure the miter slot is aligned with the bandsaw
blade (see
Page.29
).
3.
If the fence is mounted on the left-hand side of the
blade, remove it and remount it next to the miter
slot.
4.
Loosen the four cap screws located on the top face
of the fence (see
Figure.42
).
5.
Adjust the fence face parallel with the edge of the
miter slot, as shown in
Figure.43
.
6.
Tighten the cap screws that secure the rail to the
table, being careful not to move the fence.
NOTICE
Adjusting.the.fence.parallel.to.the.miter.slot.does.
not.guarantee.straight.cuts..The.miter.slot.may.
need.to.be.adjusted.parallel.to.the.side.of.the.
blade..Refer.to.the."Aligning.Table".instructions.on.
Page.29..
Note:.
Refer to the
Calibrating Fence Pointer
section on
Page 57
for instructions on adjusting
the fence pointer.
Summary of Contents for W1825
Page 73: ...Model W1825 For Machines Mfd Since 07 15...
Page 76: ......
