-48-
Model W1825 (For Machines Mfd. Since 07/15)
SE
RV
IC
E
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
.
General
Checking.and.Tensioning.
V-Belt
To ensure optimum power transmission from the motor
to the blade, the V-belt must be in good condition
and operate under proper tension. The belt should be
checked for cracks, fraying, and wear. Belt tension should
be checked at least every 3 months—more often if the
bandsaw is used daily.
Parts.Needed:.
No.
V-belt A42 ............................................. X1825093
Tools.Needed:.
Qty
Ruler ..............................................................1
Hex Wrench 6mm ...............................................1
Wrench 17mm ...................................................1
Checking.V-Belt
1.
DISCONNECT BANDSAW FROM POWER!
2..
Open the wheel covers.
3.
Note the condition of the V-belt. If the V-belt is
cracked, frayed, or glazed; they should be replaced.
4.
Push the center of the V-belt. Note the amount of
deflection (see
Figure.71
). If deflection is more than
3
⁄
4
", tension the V-belt.
Figure.71.
V-belt deflection.
Bandsaw
Wheel
Deflection
Motor
Wheel
3
⁄
4
"
MAKE. SURE. that. your. machine. is.
unplugged.during.all.maintenance.pro-
cedures!.If.this.warning.is.ignored,.seri-
ous.personal.injury.may.occur.
Summary of Contents for W1825
Page 73: ...Model W1825 For Machines Mfd Since 07 15...
Page 76: ......
