-36-
Model W1825 (For Machines Mfd. Since 07/15)
O
PE
R
ATIO
NS
Table.Tilt
To.tilt.the.table,.do.these.steps:
1..
DISCONNECT BANDSAW FROM POWER!
2. Loosen the table tilt lock lever shown in
Figure.51
.
3.
To tilt the table to the right, turn the table tilt
handwheel clockwise (see
Figure.51
).
4.
To tilt the table to the left, turn the table
tilt handwheel clockwise one turn, lower the
positive stop bolt, then turn the handwheel
counterclockwise.
5.
Secure the table tilt lock lever (see
Figure.51
).
6.
Follow "Positive Stop" instructions on
Page.31
for
resetting the stop bolt for horizontal (0º) operations.
Figure
51
. Table tilt controls.
Foot Brake
Table Tilt
Handwheel
Guide.Post
The guide post, shown in
Figure.52
, connects the upper
blade guide assembly to the bandsaw. The guidepost
allows the blade guide assembly to move up or down
to be as close to the workpiece as possible. In order to
cut accurately and safely, the bottom of the blade guide
assembly must be no more than 1" above the workpiece
at all times—this positioning provides the greatest blade
support and minimizes the amount of moving blade
exposed to the operator.
To.adjust.the.blade.guide.assembly.on.the.guide.post,.
do.these.steps:
1..
DISCONNECT BANDSAW FROM POWER!
2.
Make sure that the blade tension, blade tracking,
support bearings, and blade guides are adjusted
correctly.
3.
Loosen the guide post lock knob shown in
Figure.52
.
Figure
52
. Guide post controls.
Guide Post
Handwheel
Guide Post
Lock Knob
Guide Post
Blade Guide
Assembly
Blade
Guard
Table Tilt
Lock Lever
Summary of Contents for W1825
Page 73: ...Model W1825 For Machines Mfd Since 07 15...
Page 76: ......
