Shop fox W1825, Owner'S Manual

Page: 18 / 76

-16-
Model W1825 (For Machines Mfd. Since 07/15)
SE
TU
P
Assembly
Figure.9. Quick-release tension lever.
Figure.10. Positive stop bolt location.
Tighten
Loosen
Figure.12.
Table tilt assembly screws.
Figure.11.
Mounting the table.
Table Lock
Lever
To assemble the bandsaw, do these steps:
1. Loosen the blade tension by rotating the quick
release tension lever clockwise, as shown in
Figure.9 .
2. Open the upper and lower covers and remove the
blade.
3. Thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 90 hex bolt (positive stop bolt).
4. Thread the positive stop bolt into the threaded hole
on the bandsaw body, as shown in Figure.10 . Ensure
the head of the bolt is not higher than the trunnions.
. Note:.
Instructions for adjusting the table to the
blade are covered in the
Positive Stop
section on
Page 31 .
5. Ensure that the table tilt lever is tightened and the
trunnion is secure before proceeding to the next
step.
6. With the help of another person, lift the table onto
the trunnion.
Saw.blades.are.sharp..Handling.them.may.cause.
laceration.injuries..To.reduce.this.risk,.wear.leather.
gloves.when.handling.
7. Secure the table to the trunnion using (4) M8-1.25
x 25 hex bolts, 8mm lock washers, and 8mm flat
washers, as shown in
Figure.11
.
8. Loosen the (4) M8-1.25 x 20 button head cap screws
that secure the guide bracket to the guide bracket
plate shown in
Figure.12
.
The. table. is. HEAVY.. Get. help. when. lifting. and. use.
proper. lifting. techniques. to. reduce. the. risk. of.
injury.
Hex Bolts
Positive Stop
Bolt
x 4