-15-
M1036 Micro Mill
SE
T
U
P
Installation of the compound slide table is not necessary
when using the mill as a drill. The compound slide table
can be moved in the X and Y axis for use with milling
cutters.
To.install.the.compound.slide.table,.do.these.steps:
1..
Thread the handwheel handles into the handwheels.
2.
Remove the fence from the base if installed.
3.
Slide (4) M6-1 T-nuts into the T-slots, place the
compound slide table over the T-slot nuts, and
loosely thread the (4) M6-1 x 25 cap screws as shown
in
Figure.9
.
4.
Measure at the front and back of the compound
slide table as shown in
Figure
10
to make sure the
compound slide table is parallel to the base.
5.
Secure the compound slide table by tightening the
cap screws.
Compound.Slide.Table
Figure.9..
Cap screw and t-nut installation.
Figure.10.
Aligning the compound slide
table.
Figure.11.
Securing the optional vise.
To.install.the.optional.vise,.do.these.steps:
1.
Slide the T-nuts into the compound slide table.
2.
Place the vise on the compound slide table and
loosely secure it by threading (2) M6-1 x 30 cap
screws through the vise and into the T-slot nuts, as
shown in
Figure.11
.
3.
Align the vise parallel to the compound slide table
and tighten the cap screws.
Vise
Cap Screws
Cap Screws
