Shinko DCL-33A, Instruction Manual

Page: 15 / 56

15
5.4 Auxiliary Function Setting Mode 2
Character Name, Description, Setting Range Factory Default
Input type K (–200 to 1370 )
• Selects a sensor type and temperature unit from thermocouple
(10 types), RTD (2 types), Direct current (4 types) and DC voltage (4 types) and
/
.
• When changing input from DC voltage to other inputs, detach the sensor
connected to this controller, then change the input. The input circuit may break if
the input is changed with the sensor connected
.
K –200
–199.9
J –200
R 0
S 0
B 0
E –200
T –199.9
N –200
PL- 0
C (W/Re5-26) 0
Pt100
–199.9
JPt100 –199.9
Pt100 –200
JPt100 –200
to
to
to
to
to
to
to
to
to
to
to
to
to
to
to 1370
400.0
1000
1760
1760
1820
800
400.0
1300
1390
2315
850.0
500.0
850
500
K –320
–199.9
J –320
R 0
S 0
B 0
E –320
T –199.9
N –320
PL- 0
C (W/Re5-26) 0
Pt100 –199.9
JPt100 –199.9
Pt100 –300
JPt100 –300
to
to
to
to
to
to
to
to
to
to
to
to
to
to
to 2500
750.0
1800
3200
3200
3300
1500
750.0
2300
2500
4200
999.9
900.0
1500
900
4 to 20 mA –1999 to 9999 (Externally mounted 50 shunt resistor)
0 to 20 mA –1999 to 9999 (Externally mounted 50 shunt resistor)
0 to 1 V –1999 to 9999
0 to 5 V –1999 to 9999
1 to 5 V –1999 to 9999
0 to 10 V –1999 to 9999
4 to 20 mA –1999 to 9999 (Built-in 50 shunt resistor)
0 to 20 mA –1999 to 9999 (Built-in 50 shunt resistor)
Scaling high limit 1370
• Sets the scaling high limit value.
• Setting range: Scaling low limit to input range high limit
(For DC voltage, current input, the placement of the decimal point follows the selection.)
Scaling low limit –200
• Sets the scaling low limit value.
• Setting range: Input range low limit to scaling high limit
(For DC voltage, current input, the placement of the decimal point follows the selection.)
Decimal point place No decimal point
• Selects the decimal point place.
Not available if thermocouple or RTD is selected in [input type].
• : No decimal point
: 1 digit after decimal point
: 2 digits after decimal point
: 3 digits after decimal point
PV filter time constant 0.0 sec
• Sets the PV filter time constant.
If the set value is too large, it affects control results due to the response delay.
• Setting range: 0.0 to 10.0 seconds
OUT1 high limit 100%
• Sets the OUT1 high limit value.
• Available for direct current output. Not available if OUT1 is in ON/OFF control.
• Setting range: OUT1 low limit value to 100%
(Direct current output type: OUT1 low limit value to 105%)