Shinko CHC-S1245, Operation Manual

Page: 17 / 61

Chapter 2. Installing and Set Up
2-6
Function of Each Part
Name Function
Upper Cover
This cover may be opened to exchange the ink ribbon inspect and clean
the thermal head and to remove the jammed paper.
<Caution> Upper cover must be opened and closed gently. Thermal head
is mounted inside this upper cover.
Upper Cover Open
Lever Pull this lever to open the upper cover.
<Caution> Do not pull this lever during printing.
Operation Panel
Control buttons, LCD and printer status display lamps are located on the
panel.
Power Switch
This switch turns on/off the power of the printer. When the “｜” marked
side of the switch is pressed, the power is turned on.
When the
“○” marked side of the switch is pressed, the power is turned
off.
<Caution> Once the printer is turned off, wait at least 3 seconds before
turning it on again.
Paper Cover
Open this cover to replace paper in the paper box.
<Caution> Open and close this cover carefully.
Power Connector To be used to connect the power cord.
USB Connector To be used to connect the USB cable.
Thermal Head
Print Head for thermal transfer printing.
<Caution> Do not touch the thermal head, because it gets hot when
printing and also it can cause the damage to the thermal
head.
Platen Roller Rubber roller to feed the paper.
Dust Box
Piece of paper come out from each print will be corrected into this box.
Make sure to dispose the dust every time exchange the paper.
Cleaning Roller
Rubber roller to remove the dust on the paper. Located in front side and
rear side.
Filter This filter avoids the dust in the air to get into to the printer.