Shini SICC-120A-R2, Manual, Page: 32 / 44

32(44)
Display the cause of fault
When the external alarm signal of
current fault becomes free, the key
of
under the “ interface of fault
checking ” can be pressed to give a
reset alarm, and then the unit will
start again and the screen will
automatically skip to the
“ main
interface ” .
If there are many faults, keys of
and can be pressed to check
other alarms of them.
Note: under the “ interface of
fault checking ” , can only be
pressed to reset the fault of
current selected unit. If you want
to reset the fault of other units,
you must firstly switch to the
target unit and then repeat the
operation.
4.2.5 Password Input and Change
Enter the interface of password
input, and the cursor blinks after
is pressed. At that time, keys of
and can be pressed to
change the value. When you are
sure the displayed number is
correct, press the key of . If the
password is correct, the interface
would automatically skip to the
next one; if the password is not the
right one, you would be prompted
to input the password again.
Password error:
Enter the interface of password
input, and the cursor blinks after
is pressed. At that time, keys of
and can be pressed to
change the value. When you are
sure the displayed number is
correct, press the key of , and the
password can be changed.
Change the value into 5 after
pressing the key of
, and press
this key again to affirm the current
clock password.