Shini SAL-10HP-UGP, Manual

Page: 56 / 61

56(61)
4.6.2 Alarms
Alarm information display and relative solutions.
Red alarm
light
Code Possible reasons Solutions Remarks
[A.01]
Material shortage alarm [F.9]
1. Material loading time is too
short.
2. Can not get any materials.
3. Conveying hose blocked,
4. Not enough suction power.
1. Add material.
2. Increase material
conveying time.
3. Stop the machine and
check the conveying
hose.
The alarm will be
cleared when the
machine can again load
the material, or by
pressing ENT on the
control panel or by
cutting off power supply.
[A.03]
Filter trouble alarm
1. Filter blocked
1. Stop the machine to
clean filter screen or
replace it.
The alarm will be
cleared by cutting off the
power or press ENT on
the control panel.
[A.04]
Non-operation alarm [F.10]
1. After a certain period time of
material shortage, the
machine will stop working.
Please refer to the
solutions of [A.01] or
modify the value of
[F.10].
The alarm will be
cleared by cutting off the
power or press ENT on
the control panel.
Please fix the control
panel onto the machine
and modify its value.
[A.05]
First carbon brush alarm
When carbon brush working
hours [F.17] gets to a certain
point(800 hrs), [F.14] will raise
the alarm.
Please prepare the
carbon brush for
replacement.
The alarm will last for 5
minutes.
The machine will repeat
the alarm every 15
minutes until you reset
carbon brush working
hour.