Shini SAL-10HP-UGP, Manual

Page: 58 / 61

58(61)
5. Trouble-shooting
Failures Possible reasons Solutions
1. Main power switch or control
switch is off or poorly connected.
1. Turn on main switch or control switch
and make sure they are well
connected.
2. Poor contact or broken of
magnetic proximity switch /
capacitor contactor. 2. Repair or replace.
Motor does not work
long after material
discharge.
3. Signal wire is broken. 3. Reconnect signal wire.
1. No material left for conveying. 1. Add the material.
2. Air pipe leakage. 2. Firmly lock the air pipe or replace.
Motor can not fully
load material hopper,
or machine sounds
material shortage
alarm.
3. Filter is jammed. 3. Clean the filter.
Motor can not work. Motor is burn out. Repair or replace.
Fuse melts when turn
on the machine.
Short circuit or motor is burn out. Check electrical circuit.
Motor keeps on
working after material
hopper is full-loaded.
PCB problems. Repair or replace.