11
7-1. Turning on the LED
Perform a pre-operation inspection before using the LED. (Refer to "10.
Inspection/Maintenance".)
Remove the lamp fitting cover.
(Refer to "6-1. Removing the Lamp Fitting Cover".)
Remove the bundling buckle and securing the
balloon fabric.
Adjust the lamp fitting direction (vertical angle
and rotation). (Refer to "5-1. Using the Lamp
Fitting".)
<Note>
Connecting the power cord and with the Output switch at "ON" causes sparks to be
generated between the outlet and plug. Always be sure that the Output switch is "OFF"
before connecting the power cord.
Connect the power cord to the outlet.
Turn the toggle switch to "ON" to turn on the LED.
Raise the mast and adjust the lamp fitting to the desired height.
(Refer to "5-2. Lifting/Lowering the Mast".)
7-2. Turning off the LED
Lower the mast. (Refer to "5-2. Lifting/Lowering the Mast".)
Turn the toggle switch to "OFF" to turn off the LED.
<Note>
Do not turn off the LED by removing the power
plug. Doing so causes sparks to be generated
between the outlet and plug.
After turning the LED off, open the balloon fabric zipper, and wait five minutes for the
LED to cool down.
<Note>
Bundling up the balloon fabric immediately causes balloon fabric worn out due to the
heat of the LED.
Place the lamp fitting so that it is horizontal. (Refer to "5-1. Using the Lamp Fitting".)
Wrap the balloon fabric around the lamp guard and bundle it by using the buckle.
Cover with the lamp fitting cover. (Cover in the reverse order of removal.)
<Note>
When closing the zipper, be careful that the balloon fabric is not caught in the zipper.
As the cord stopper might slide out of position, use the cord stopper to make the cover
opening smaller before tying off the cord.
2
1
3
4
5
6
1
2
3
4
5
6
Buckle
