Shindaiwa DGW500DM, Owner'S And Operator'S Manual

Page: 35 / 44

- 32 -
Inspection Item
Pre-
Operation
Inspection
Inspection Period
50th
hour Every 100
hours
Every 200
hours
Every 400
hours
Every
1,000
hours Every
2,000
hours
20
Replace Fuel/Cooling
Water/Oil Hoses and
Anti-Vibration Rubber
or
2 years
21
Adjust/Lap Clearance of
Air Intake/Release
Valves
Adjust-
ment
Lapping
22
Inspect/Adjust
Clearance of Fuel
Injection Valves
23
Inspect/Adjust Fuel
Injection Pump
(1) Changing the Engine Oil
1) Remove the oil plug.
2) Remove the oil drain plug and drain the
engine oil.
3) Tighten the oil drain plug.
4) Add oil through the oil inlet, while checking
the oil level using the oil gauge, until it
reaches the maximum level. (Fill with
approx. 6 L.)
5) Tighten the oil plug.
<Note>
•
Refer to section "6-1. Engine Oil Inspection" for the types of engine oil.
•
Replace the packing of the oil drain plug with a new part each time the oil is
changed.
•
Packing part no.: 6C090-58961 (Kubota part no.)
•
After tightening the oil drain plug, operate the engine for a short period and check
that there is no oil leakage. Stop the engine when completed.
(2) Changing the Oil Filter
1) Drain the engine oil according to the
procedures of "(1) Changing the Engine Oil".
2) Remove the oil filter using a filter wrench.
3) Apply a thin layer of oil to the gasket of a new
oil filter.
4) Screw in the oil filter by hand and securely
tighten by hand (do not use a filter wrench)
after the gasket contacts the seal surface.
5) Add engine oil.
1st time 50th hour
2nd time
and after
Every 100 hours
1st time 50th hour
2nd time
and after
Every 200 hours
Oil Gauge
Oil Plug
Oil Inlet
Oil Drain Plug
Oil Plug
Oil Inlet
Oil Filter
Gasket