- 13 -
(2) Battery Charge Monitor Lamp
The battery charge monitor lamp ("CHARGE") lights up and the engine is
automatically stopped if battery charge fails during operation. If this occurs, it is
probable that there is fan belt damage or a wiring fault. Request repair at the retail
outlet where the equipment was purchased.
(3) Oil Pressure Monitor Lamp
The oil pressure monitor lamp ("OIL PRESS") lights up and the engine is
automatically stopped if the engine oil pressure drops during operation. If this
occurs, inspect the engine oil level and fill with engine oil until it reaches the
maximum level.
<Note>
•
The oil pressure monitor cannot detect oil deterioration. Change the engine oil
periodically. (Refer to section "11.(1) Changing the Engine Oil" .)
•
The charge monitor cannot detect battery deterioration or insufficient battery fluid.
Inspect the battery fluid level periodically.
(
Refer to section "6-6
.
Battery
Inspection".
)
•
Inspect the fuses if the engine is automatically stopped and none of the monitor
lamps ("WATER TEMP", "CHARGE" and "OIL PRESS") light up. (Refer to section
"4
.
Part Names" for fuse location.)
If a fuse has blown, it is probable that there is a fault in an electric part or the
wiring. Request repair at the retail outlet where the equipment was purchased.
(4) Overheat Monitor Lamp
The overheating monitor lamp ("OVERHEAT") flash and the equipment cuts the
output if the equipment is used excessively over the duty cycle or output. Then it is
probable that overloading is the cause. Use within the rated duty cycle or output.
(Refer to section "13
.
Troubleshooting" for Error Code Display.)
<Note>
•
There may be a case that the lamp will not flash, depending on the welding type
or the weather condition.
5-8
.
.
.
.
Frequency Selector
Warning: Injury/Electric Shock
•
Do not operate the equipment with any doors or covers open. There is a danger
of hair, body parts and other items being caught up in moving parts such as
cooling fans and belts.
Caution: Burn
•
The engine, muffler and similar parts are extremely hot during operation and
immediately after stopping the equipment. Never touch hot parts.
Caution: Physical and Secondary Damage
•
Set the frequency in accordance with the devices using the equipment.
Summary of Contents for DGW500DM
Page 2: ......
Page 42: ... 39 14 Engine Wiring Diagram ...
Page 43: ... 40 15 Generator Wiring Diagram ...
Page 44: ... 2014 ...