Shindaiwa DGW500DM, Owner'S And Operator'S Manual

Page: 18 / 44

- 15 -
6. Pre-Operation Inspection
<Note>
•
Connect using a plug with a grounding pole.
•
If using a plug without a grounding pole, perform grounding work and check that
used devices are connected to ground.
•
Securely ground the bonnet grounding terminal to the metal frame of the vehicle if
transporting the equipment by truck or trailer.
(3) If a Ground Fault Circuit Interrupter Operates
Caution: Electric Shock/Injury
•
Always be sure to turn off the power switches of all devices using the equipment
when turning on the equipment breakers after a ground fault circuit interrupters
operates. Leaving on the power switch of a device using the equipment when the
equipment breaker is turned on could result in the sudden operation of the
corresponding device.
The GFCI receptacle reset button pop out when a ground fault circuit interrupters
operate. When this occurs, immediately stop the engine and repair the ground fault
location.
After repairing all faults, press the GFCI receptacle reset button until it stays in.
<Note>
•
There is a fault in the ground fault circuit interrupters if
the GFCI receptacle LED lamp flush and reset button
pop out. Request repair at the retail outlet where the
equipment was purchased.
5-10. Emergency Stop Switch
Press the emergency stop switch to stop the engine
immediately.
After pressing the emergency stop switch, securely return
the starter switch to the "STOP" position and turn the
emergency stop switch clockwise to reset the switch.
T
Warning: Injury/Electric Shock
•
Do not operate the equipment with any doors or covers open. There is a danger
of hair, body parts and other items being caught up in moving parts such as
cooling fans and belts.
•
Always be sure to stop the engine and remove the starter key before performing
any equipment check or maintenance.
Warning: Fire
•
Always be sure to wipe up any spilled fuel or oil.
•
Absolutely never use the equipment if there is a fuel, oil or cooling water leak, and
be sure to always repair the leak before using.
•
Absolutely never inspect or perform maintenance to the equipment near fire or
other open flame.
Stop
Reset
GFCI
Receptacle
LED Lamp