Shindaiwa DGW300M, Owner'S And Operator'S Manual

Page: 27 / 36

- 24 -
④
Checking the oil level by the oil level gauge, add oil into the oil filler to fill up to
the max level (Approx. 2.5L).
⑤
Reinstall the oil plug hand tight.
< Caution >
•
Refer to
『
6-1. Checking Engine Oil
』
to select engine oil.
•
Change the packing, whenever changing oil.
•
Packing No.
：
6C090-58961 (Kubota)
•
After reinstalling the oil drain plug tightly, keep the engine drive for a while to check
no engine oil leakage and then stop the engine.
(2) Oil Filter Change
①
Drain the engine oil completely, as
described in
『
11 (1) Oil Change
』
.
②
Loosen and remove the oil filter,
using an oil filter wrench.
③
Smear a little engine oil on the
rubber gasket of a new filter.
④
Screw the new filter into place and
tighten it by hand until the gasket
contact the seat. Then, give it
additional
『
1.1/4 Turn
』
to seat the
filter, using an oil filter wrench.
⑤
Supply oil and install the filler cap.
< Caution >
•
If an oil filter wrench is not available, contact with authorized distributor.
•
Oil Filter Part No.
：
15853-32436 (Kubota)
•
After the engine oil supply, keep the engine drive for a while to check no engine oil
leakage and then stop the engine.
(3) Clean/Change Air Filter Element
Clean 1
st
50 hours and Every 100 hours afterwards
Change Every 400 hours
①
Disconnect the air cleaner cap by releasing the clips.
②
Remove the air element.
First Time 50 hour mark
2
nd
or after Every 200 hours
OIL FILTER
CLIP
GASKET
AIR CLEANER
ELEMENT
CLIP
AIR CLEANER
CAP
CLIP
AIR CLEANER