Shimaden PAC18 Series, Instruction Manual

Page: 23 / 32

－23－
1-11. Current limiter (optional)
The current limiter limits output current value to 120% of rated current.
Sets allocation of the function. Lower the display to 0 when allocating to VR.
(If allocating to VR, current limit is 100% of rated current.)
This screen is not displayed for cycle calculation zero voltage switching
control or complex control.


Initial value: 100%
 ：
Key input allocation range:
 
0 – 120% of rated current
  ：
Allocate to VR1 (below 0.0)
 
 ：
Allocate to VR 2
Entered by

Note
VR currently being used cannot be selected by key sequence ‘1-7. Ramp
lower limit setting’ and key sequence ‘1-8. Ramp higher limit option.’ If
allocating to the current limiter, cancel VR allocation of key sequence ‘1-7.’
or key sequence ‘1-8.’
1-12. Heater break alarm current (optional)
Sets value for which alarm is to be output for heater break in percent of set
standard value. (Alarm however does not occur if heater break alarm
current is set to 0%.)

 Initial value: 0%
 
Entered by

 
Range: 0 – 100%
1-13. Communication protocol (optional)
This screen is displayed if you have selected communication (optional).
Displays communication protocol.


 
: MODBUS (RTU)
1-14. Communication address (optional)
This screen is displayed if you have selected communication (optional).
Sets communication address.


Initial value:

 
Entered by

 
Range: 1– 255
1-15. Communication speed (optional)
This screen is displayed if you have selected communication (optional).
Sets communication speed.

 Initial value: 
 ：
19200 bps
  
 ：
9600 bps
Entered by

1-16. Communication parity (optional)
This screen is displayed if you have selected communication (optional).
Sets communication parity.

 Initial value: 
 ：
No parity
 

  ：
Even parity
 
 ：
Uneven parity
Entered by 
1-17. Communication Stop bit (optional)
This screen is displayed if you have selected communication (optional).
Sets stop bit.

 Initial value: 
 ：
Stop bit 1
  
 ：
Stop bit 2
Entered by 
1-18. Communication delay (optional)
This screen is displayed if you have selected communication (optional).
Sets communication delay.

 Initial value: 
 
Entered by

 
Range: 10– 200 ms
Sets time from reception to transmission.
Sets delay time if equipment with slow response is connected.
By doing so, you can avoid collision of data in the communication line.

Switches to key sequence ‘1-0. Initial screen.’