E
N
G
L
IS
H
• Depending on your speaker type, you can select one of these following speaker types.
• Front, Center, Surround and Surround Back(or Front Height) speakers :
LARGE(or L) : Select this when connecting speakers that can fully reproduce sounds below crossover frequency.
SMALL(or S) : Select this when connecting speakers that can not fully reproduce sounds below crossover frequency.
When this is selected, sounds below crossover frequency are sent to the subwoofer or speakers which are set
to "LARGE" (when not using a subwoofer).
NO : Select this when no speakers are connected. When this is selected, sounds are sent to the speakers which are not set to
"NO".
( ) : Selectable for Surround Back speakers.
• Surround Back speakers :
x2/x1 : Select the desired depending on the number of speakers connected to SURROUND BACK terminals.
• Subwoofer :
YES : Select this to output LFE signals and bass frequencies of channels set to “SMALL” form the subwoofer.
NO : Select this when the subwoofer is not connected. The bass frequencies are output from other speakers.
■
Notes
:
• When speakers are set to "SMALL", you should set their crossover frequency correctly according to their frequency
characteristics. (For details, refer to "When selecting the CROSSOVER" on page 46.)
• When the "F"(Front) is set to "SMALL", “C”(Center), “S”(Surround) and "SB"(Surround Back) (or “FH”(Front Height)) cannot be
set to "LARGE" and the “SW”(Subwoofer) cannot be set to “NO”.
• When the "S"(Surround) is set to "SMALL", the "SB"(Surround Back) cannot be set to "L"(Large).
45
3.
Press the CURSOR LEFT(
◀
)/ RIGHT(
▶
) buttons to set the selected speaker as desired.
4.
Repeat the above steps 2 and 3 until the speakers are all set to the desired mode.
■
About the speaker size
• Select "LARGE" or "SMALL" not according to the actual size of the speaker but according to the speaker's capacity for playing
low frequency (bass sound below frequency set on the "CROSSOVER" menu) signals.
• If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage
the speakers) to determine the proper setting.
When selecting the CONFIGURATION
1.
Press the CURSOR UP(
▲
)/DOWN(
▼
) buttons to select the "CONFIG", then press the ENTER button.
2.
Press the CURSOR UP(
▲
)/DOWN(
▼
) buttons to select the desired speaker.
RD-7505(A)_ENG_101115_RD-7505(A)_ENG 2010-11-16 오전 10:36 페이지 45
All manuals and user guides at all-guides.com
