26
Figure 4
‑
14 Power setup interface
Methods of modifying: click on "Registration" column of the corresponding power to show
"
√
", press OK button to save the setup and exit, otherwise press Cancel button to retain the
original setup and exit.
The user is not suggested to cancel the registration of host power supply unless special
debugging is required.
4.1.8 Printer setup
The printer setup interface is as follows:
Figure 4
‑
15 Printer setup
Method of modifying: the transmission rate of printer is fixed to 9600. Click on
"Registration" column of the corresponding power to show "
√
". Press "OK" button to save the
setup and exit, otherwise press "Cancel" button to retain the original setup and exit.
"SPRINTER-02" system is set as thermal printer. The jumper hat on
the printer shall be removed or jump to one side. Its baud rate is set as 9600BPS.
4.1.9 Rename system
The system name in the title bar can be changed by selecting the function. The interface is as
follows:
Figure 4
-
16 System rename interface
4.1.10 LCD Auto-off
If choose this function("
"is shown in front of the submenu) , LCD will shut off
automatically after 5 minutes without system operation. Any key pressed or any move of the
mouse, LCD will turn on again.
This function is to assure the longevity of LCD, so it’s advised for the user.
