ShenPaz Focus HT, Use Manual, Page: 6 / 22

FOCUS HT Dental Porcelain Furnace Page 6 Manual version 4.3
1.3 Furnace Connection to Power Outlet

Check and ensure that the main power switch at the rear of the furnace is turned
off.

Connect the electrical power cord into the furnace power inlet. Plug the electrical
power cord into the wall power outlet.

Switch the MAIN POWER switch ON (located on the rear panel). You will hear a
single beep. The furnace is now in Stand-by mode. The word “ON” in the program
field.

Press the ON/OFF key on the front panel. The furnace is now in idle mode.

Press the [STOP/LIFT] key - the platform will descend automatically.

Place the ceramic table on the platform!!!

The furnace is now ready for the Initial Operation Procedure.
2. General Description
2.1 Connections and Controls
FRONT PANEL:
The furnace controls are located on the front panel and are
divided into 6 sections:
1.
Data keys
2.
Control keys
3.
Programming keys
4.
LCD color
5.
Temperature and Data Display
6.
Vacuum Display
REAR PANEL:
The main switch and the furnace connections are located on the rear panel.
7.
Power switch
8.
Emergency wrench inlet
9.
Muffle fuse
10.
USB Inlet for Software
uploading
11.
Power cord outlet
12.
Power muffle fuse
13.
Calibration inlet
14.
Vacuum pump inlet
15.
Vacuum pump fuse
2.2 Data Keys
Data keys are for the inserting, deleting, and changing of data.
The Data keys are:
NUMBER
S

From numbers 0 -9 .
ENTER

Confirms the selection of a program or a parameter.
CLEAR

Cancels the previous key selection.