ShenPaz Focus HT, Use Manual, Page: 5 / 22

FOCUS HT Dental Porcelain Furnace Page 5 Manual version 4.3
1. Furnace Installation
1.1 Unpacking and Positioning of furnace

Check the contents of the shipping carton, compare with the enclosed list

Take out the accessories and check the contents:
POINTS TO NOTE:

When positioning the furnace on the working bench, please keep
safe distances from the surrounding walls (approx. 20cm).

Do not place the furnace near the open window or any source of
direct airflow (like ventilator). This, in order to eliminate the
possibility of wrong temperature reading when the firing table is in
its lower position.

Placing the furnace according to the above-mentioned instruction
will guarantee the proper temperature stabilizing, heating and
cooling.
1.2 Vacuum Pump Connection

Using the rubber vacuum tube and the band supplied:
o
Connect the nozzle of the vacuum pump to the rubber vacuum
tube.
o
Connect the nozzle of the furnace to the other end of the rubber
tube.

Check the band is well secured.

Plug the electrical power cord of the vacuum pump, into the electrical
power outlet of the vacuum pump, located on the rear panel of the
furnace.

Check the position of the pump so that the vacuum tube will have an
undisturbed air flow.
Electrical cable
Firing table
Tweezers
Fuses
Emergency wrench
Vacuum hose
USB: User manual

Remove carefully the polyethylene foam.

Lift out the furnace carefully, and positioning it on its feet.

DO NOT lift the furnace by the lift shaft.

Store the carton and the polyethylene foam for future use.