ShenPaz Focus HT, Use Manual, Page: 13 / 22

FOCUS HT Dental Porcelain Furnace Page 13 Manual version 4.3
Func
tion The final stage of the UP TIME during which the muffle is
closed and the temperature does not rise for the defined
duration.
Limit
s 0 to 30 minutes.
Com
ment
s Vacuum pump will start pumping out the air before the DRY TIME
countdown begins.
If DRY TIME without vacuum required, VACUUM START temperature
value should be 5

C higher than START TEMP.
Para
mete
r HEAT RATE
Func
tion
The rate in  C or  F at which the temperature rises from
START TEMP to HIGH TEMP and from HIGH TEMP to
FINAL TEMP.
Limit
s
10

C to 100

C
Com
ment
s One of the parameters which have to be included in order for a
program to run..
Para
mete
r HIGH TEMP
Func
tion The temperature to be reached at the end of the HEAT
RATE or
intermediate temperature when the value of the
FINAL TEMP is higher
Limit
s
100

C to 1100

C in normal
100

C to 1180

C in HT
Com
ment
s Must not be less than “VACUUM OFF” temperature. (When a vacuum
is included in the program).
One of the parameters which have to be included in order for a
program to run.
Param
eter TEMP DELAY
Functio
n The duration of time that the furnace will remain at the
HIGH TEMP before the firing chamber is opened or
before the temperature will continue it’s rise to FINAL
TEMP (if defined) .
Limits 0 to 30 minutes (specified in minutes and seconds).
0 to 4:30 H in the HT Programs
Comm
ents Intermediate delay when FINAL TEMP is higher than HIGH TEMP.
Param
eter FINAL TEMP
Functio
n An additional heating or cooling mode. May be lower or
higher than HIGH TEMP. If higher - heating will be
reactivated. If lower - chamber will be opened slightly to
enable quick cooling to the FINAL TEMP value. Then the
platform will close the muffle and the temperature will
stabilize on FINAL DELAY temperature.
Comm
ents Optional parameter. In case not in use should remained
blank
Limits
100

C to 1100

C in normal