ShenPaz Focus HT, Use Manual, Page: 3 / 22

FOCUS HT Dental Porcelain Furnace Page 3 Manual version 4.3
Warning
You have available one of the most precise dental furnaces equipped with a heating
muffle made by the original manufacturer of this technology with an experience of
more than 25 years in the dental laboratory industry.
IN ORDER TO PRESERVE THIS PRECISION AT ALL TIMES, PLEASE BE SURE
TO ATTENTIVELY READ THE FOLLOWING INSTRUCTIONS PRIOR TO USING
THE FURNACE!

Please keep your furnace in an ambient temperature for any storage.
 Prior to carrying out maintenance work on the furnace or in case of mechanical failure,
firstly be sure to completely shut down the device. To do so, switch the main switch
(POWER) on the back of the furnace to OFF and pull the power-supply plug.

Only qualified technicians and experts recommended by the furnace supplier should open
the furnace.
 Do not attempt to open the furnaces without authorization since this will void the guarantee.
For any necessary repair and maintenance work, consult your Shenpaz device servicing
center.
 In case of a necessary replacement of fuses, proceed as follows:
1) Pull the power-supply plug.
2) Replace the fuse.
3) Be sure the correct safety fuse parameter is indicated on the spare fuse.
 Your new furnace has a full recovery system on any power failure

In case of a long external power failure and when it is needed to manually open the furnace
proceed as follows:
1) Pull the power-supply plug.
2) Lower the support. To do so, insert the supplied crank into the hexagonal screw
on.
ATTENTION!
When operating the furnace, a Refractory support must always be on the lift tray!
ATTENTION!
Take out the furnace with the assistance of two persons. To do so, each person will
take a side by holding the bottom of the furnace with one hand and the top side with
the other hand.
ATTENTION!
Do not pull out the furnace by its support in order to avoid damages.