Operating Instructions
Page 45
RevA
9.2. Basic AI Setup
This section will get you started with the basics
of AI on the Teric. Advanced setup and detailed
descriptions will be covered in later sections.
Install the Transmitter
Before using the AI system, you will need to install
one or more transmitters on a scuba tank first stage
regulator.
The transmitter must be installed on a first stage
port labeled “HP” (high pressure). Use a first stage
regulator with at least two HP ports, so that a backup
analog submersible pressure gauge (SPG)can be
used.
Position the transmitter such that it is on the same
side of your body as you wear your Teric handset
(FIGURE 5)
. Range is limited to approximately 3 ft (1 m).
A high-pressure hose may be used to relocate the
transmitter for better reception or convenience. Use
hoses rated for a working pressure of 4500 PSI (300
Bar) or higher.
Range
3 ft (1 m)
Range
3 ft (1 m)
Use a wrench (11/16” or 17mm) to
tighten or loosen the transmitter
Avoid hand tightening or
loosening, as this can stress the
body of the transmitter.
A backup SPG is recommended
Install transmitter on 1st stage HP port
Install transmitter on the same side of your body as the handset�
Range is approximately 3 feet (1 m)�
Summary of Contents for Teric
Page 1: ...Operating Instructions...
