Seite 20 von 28
MAINTENANCE AND CLEANING
EMPYING THE WATER TANK
As soon as the “Watertank full”-Indicator lights up, the watertank has to be emptied.
The dehumidifier will turn off automatically and the buzzer will beep for 15 mintutes.
.
Lightly press the sides of the tank with both hands and pull the
tank out gently.
After that discard the collected water.
Make sure that the watertank is fully dry before you put it back
into the dehumidifier.
When replacing the watertank, press the tank firmly into place
with both hands. If the tank is not positioned properly, the
“Watertank full” sensor will be activated, and the dehumidifier
will not operate.
PLEASE NOTE:
1. Do not remove the float from the water tank. The Water full-
sensor will no longer be able to detect the water level correctly
without the float and water may leak from the water tank.
2. If the drainage tank is dirty, wash it with lukewarm water.
3. Do not use detergent, scouring pads, chemically treated dust cloths, gasonline,
benzene, thinner or other solvents, as these can scratch and damage the tank.
CONTINUOUS WATER DRAINAGE
You have the option of installing a permanent water drain if you want to operate the device
for a longer period and do not want to empty the water tank manually
To install the permanent water drain, please proceed as
follows:
1. You need a hose with an inner diameter of 10mm for
permanent water drainage.
2. First open the water tank and remove the plug of the
water drain.
3. Now attach one end to the outlet.
4. Insert the other end of the hose into a collecting vessel or
a drain, whereby the hose must not be laid higher than
the drain valve and must not be kinked.
5. You can then close the water tank again
CLEAN THE FILTER
