Sharp XV-Z17000, Operation Manual

Page: 44 / 82

-42
5
Setting the Video System
The video input system mode is factory preset to “Auto”;
however, a clear picture from the connected audio-visual
equipment may not be received, depending on the video
signal difference. In that case, switch the video signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL-M
PAL-N
PAL-60
* When reproducing NTSC signals in PAL video equip-
ment.
Note
• The video signal can only be set in VIDEO or
S-VIDEO mode.
•
When “Video System” is set to “Auto”, you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal.
6
Setting the Video Setup
Selectable items Description
0 IRE Sets the black level to 0 IRE.
7.5 IRE Sets the black level to 7.5 IRE.
Note
• This function is available for the following
signals.
With COMPONENT or COMPUTER/
COMPONENT input:
- 480
I
With S-VIDEO or VIDEO input:
- NTSC3.58
7
Adjusting the Dynamic Range
An optimum picture may not be displayed if an HDMI-
capable device’s output signal type and the projector’s
input signal type do not match. If this should occur,
switch “Dynamic Range”.
Selectable items Description
Auto In most circumstances, “Auto” should
be selected.
Standard When the black levels of the image
show banding or appear faded, select
the item that results in the best picture
quality.
Enhanced
8
Signal Info
Input signal information is displayed.
Menu operation
⇒
Page
35
Computer Image Adjustment (“SIG-ADJ” Menu)
(Continued)
XV-Z17000̲E̲US.indb 42 XV-Z17000̲E̲US.indb 42 2010/12/17 11:16:33 2010/12/17 11:16:33