11/8/24
08_XL-E171DVH_EN.fm
E-35
Timer and sleep operation (Remote
control only) (continued)
The tuner, DISC, USB, Audio In and Line In can all be
turned off automatically.
To confirm the remaining sleep time:
To cancel the sleep operation:
Press the ON/STAND-BY button whilst “SLEEP” is
indicated. To cancel the sleep operation without setting
the unit to the stand-by mode, proceed as follows.
Sleep and timer playback:
For example, you can fall asleep listening to the radio and
wake up to CD in the next morning.
Enhancing your system
The connection lead is not included. Purchase a
commercially available lead as shown below.
Note:
To prevent noise interference, place the unit away from the
television.
●
Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
●
Before plugging in or unplugging the headphone,
reduce the volume.
●
Be sure your headphone has a 3.5 mm (1/8") diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
●
Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
■
Sleep operation
1
Play back the desired sound source.
2
Press the SLEEP button.
3
Within 5 seconds, press the Direct Search button to set
the time. (1 minute ~ 99 minutes)
4
“SLEEP” will appear.
5
The unit will enter the power stand-by mode
automatically after the preset time has elapsed.
1
Whilst “SLEEP” is indicated, press the SLEEP button.
1
Whilst “SLEEP” is indicated, press the SLEEP button.
2
Within 5 seconds, press the “0” button twice until
“SLEEP 00” appears.
■
To use timer and sleep operation together
1
Set the sleep time (see above, steps 1 - 5).
2
Whilst the sleep timer is set, set the timer playback
(steps 2 - 9, page 34).
Desired time
1-99 minutes
Sleep operation will
automatically stop
Sleep timer
setting
Timer playback
setting
Timer playback
start time
End time
■
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and the
video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO/LINE (INPUT) button on the remote
control or FUNCTION button repeatedly on main unit to
select AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase the
volume of the connected device.
■
Headphones
Audio cable (not supplied)
Portable audio
player, etc.