No.
Adjusting point
Adjusting conditions
Adjusting procedure
5 RGB 1 system
Make the following choice:
l
Choose the subject RI-BLK and adjust the black peak
black level
Group OUTPUT 1
level to 2.7
DC using the membrane switch or
signal amplitude
Subject
the remote control button.
-GAIN
l
Next, choose the subject
-GAIN and adjust the
(The
bar test pattern
amplitude to 3.3
Vp-p.
is outputted automatically.)
Make the same adjustment for green and blue.
For green, choose the sub-
j e c t s G l - B L K a n d
GAIN.
For black, choose the
Bl-BLK and Bl -GAIN.
2. Connect the oscilloscope to
pin
of SC1101
for red.
Pin
of
201 for green
Pin
of
D
C
301 for blue
6
RGB 2 system
1. Make the following choice:
l
Choose the subject
and adjust the black peak
black level
Group OUTPUT 2
level to 2.7
DC using the membrane switch or
signal amplitude
Subject
the remote control button.
l
Next, choose the subject
and adjust the
For green, choose the
amplitude to 3.3
Vp-p.
a n d
GAIN.
For black, choose the
and
2. Connect the oscilloscope to
.
pin
of
101
for red.
. .
Pin
of
201 for green
Pin
of
DC
301 for blue
l
Make the same adjustment for green and blue.
l
Feed the XGA gradation pattern
signal
and make sure that there is no difference in bright-
ness between adjacent vertical lines. If there is a dif-
ference, make fine adjustment by choosing the fol-
lowing subjects.
for red
for green
for blue.
7
hold pulse
phase
Feed the SXGA mode black
l
Using the membrane switch or the remote control
signal.
button, make such adjustment that the characters on
2. Make the following choice:
the adjustment menu are least blurry or overlapped.
Group OUTPUT 3
(Make adjustment at the moment when the group
Subject SH-PHASE
name
appears and the subject name
PHASE” is not yet indicated.)