E/A
No.
Adjusting point
A d j u s t i n g c o n d i t i o n s
Adjusting procedure
8
1. Feed the black-and-red
Using the membrane switch or the remote control
voltage
(25%) stripe signal (XGA).
button, adjust the
data
in order to minimize the flicker.
adjustment
If such a pattern signal is
Make the same adjustment for BC (B) and GC (G).
not available, select the
horizontal stripe signal from
the desktop pattern menu.
2. Make the following choice:
Group OUTPUT 3
Subject
(R)
9 RGB gradation
Feed the XGA green-only
l
Adjust the Gl-GAIN data until the first and second
regeneration
gradation pattern (more
gradations can be slightly recognized. (First
adjustment
than 16 steps) signal.
ally raise the Gl-GAIN level until the gradation gets
Group
OUTPUT 1
recognized, and then adjust the level by lowering it
Subject Gl-GAIN
again.)
10 RGB white
balance
Feed the XGA gray scale
l
Choose the subjects
and Bl
and adjust
signal.
the black balance of the gradation. Choose the
Group
OUTPUT 1
Rl-GAIN and Bl-GAIN and adjust the
Subject Rl-BLK
while balance (so that the entire screen looks
-GAIN (R)
less).
Bl
(B)
11 NTSC 4fsc
Choose the group VIDEO 1
l
Turn
to have the frequency counter read
to keep the unit without
14.31818 MHz
Hz.
2. Select the
system
into
3. Connect the frequency
counter between
and GND.
12 PAL 4fsc
1. Choose the group VIDEO 1
l
Turn C446 to have the frequency counter read
to keep the unit without
17.734475 MHz
Hz.
2. Select the
system
into PAL.
3. Connect the frequency
counter between
and GND.
13 Horizontal
center
1. Feed the NTSC mono-
* Using the membrane switch or the remote control
scope pattern signal.
button, adjust the data to have the same overscan.
Group VIDEO
Subject
2 3
