NOTE TO SERVICE: PERSONNEL
The light source, metal halide lamp, in the LCD
projector emits small amounts of UV-Radiation.
To ensure safety please adhere to the following:
1.
sure to wear sun-glasses when servicing the
projector with the lamp
turned “on” and the top
enclosure removed.
2. Do not operate the lamp outside of the lamp
housing.
3. Do not operate for more than 2 hours with the
enclosure removed.
Be sure to disconnect the AC plug when replacing
the lamp.
2. Allow one hour for the unit to cool down before
servicing.
3. Replace only with same type lamp. Type
rated
4. The lamp emits small amounts of UV-Radiation,
avoid direct-eye contact.
5. The medium pressure lamp involves a risk of
explosion. Be sure to follow installation
instructions described below and handle the lamp
with care.
q
Since the lamp reaches a very high temperature
during units operation replacement of the lamp should
be done at least one hour after the power has been
turned off. (to allow the lamp to cool off
Installing the new lamp, make sure not to touch the
lamp (bulb) replace the lamp by holding its reflector
[Use original replacement only.]
DANGER
Never turn the power on without
the lamp to avoid electric-shock or damage of the
devices since the stabilizer generates high
voltages at its start.
Since small amounts of UV-Radiation are emitted
from an opening between the duct cover and the
lamp housing, it is recommended to place the LENS
CAP on the opening during servicing to avoid eye
and skin exposurem (Fig. 1).
Please obtain a lens cap before servicing a mod-
els XG-XV1 E/A that is received without one.
LENS CAP
Figure 1.
