Operation References
4
Operation References
Warning Indicators
If a warning indicator appears on the screen, follow the specified instructions.
The capacity of the card is full and cannot store any more
images. Delete unnecessary images (see
page 19
) or
replace the card with a new one (see
page 9
).
The card has no images recorded in the format the camera
can recognize.
The card is not inserted or is inserted improperly. Check
that it is properly inserted (see
page 9
).
Warning indicators
Description of warning
The card is write-protected (see
pages 9, 60
).
The selected image cannot be read by this camera.
You cannot record any image with a file number bigger
than 999-9999. Format the card or replace it with a new
one.
NO C ARD
NO IMAGE S
I S FUL L
CARD
I S
CARD S L O T COVE R
OP E N
L ENS ERROR
OF F ON AGA I N
/
TURN POWER
NO.
MA X. IMAGE
I S S E T
CARD
T O
RE AD ONL Y
PROC E SS I NG WAS
S TOP P E D
CANNO T RE A D
THE
DA T A
I MAGE
B A T T E RY I S TOO LOW
TO TRANS F E R THE DA T A
The card slot cover is open. Close the cover.
The camera failed to process the data. Make sure the
operation procedure is correct.
Replace the batteries with new AA alkaline batteries or fully
charged Ni-MH rechargeable batteries (commercially
available) (see
page 7
).
You cannot set the print order to more than 999 images.
P R I NT SE T T I NG
T O
I MAGE S
9 9 9
I S UP
If you power on the camera in any of the capture modes
and the lens barrel is obstructed (e.g. by a hand, flat
surface, lens cap), it may freeze after making contact three
times. In such case, turn the power off, remove the
obstruction then power on again.
Improper connection. Check the USB connection and
make sure the card is firmly inserted in its slot (see
page 9,
57
).
D I S CONNE C T E D
VE-CG40U-001-006
02.8.27, 7:16 PM
4
