MX-FN10 DISASSEMBLY AND ASSEMBLY 6 – 3
(9) Right lower cover
1)
Loosen the screw [1].
2)
Remove the right lower cover.
(10) Side guide upper
1)
Remove the load tray. (See (1).)
2)
Remove the saddle paper holding lever. (See (2).)
3)
Remove the saddle tray. (See (3).)
4)
Remove the front cabinet. (See (4).)
5)
Remove the rear cabinet upper. (See (5).)
6)
Put the load tray supporting plate (front) [1] and the load tray
supporting plate (rear) [2] outside of the rail groove.
Note: When the load tray is on the top position, lower the load
tray by manually turning the load tray lift motor rotation
shaft (counterclockwise) so that the sensor flag attached
to the supporting plate (rear) does not make contact with
the load tray upper limit sensor.
7)
Open the center binding staple replacement door, and release
the center binding staple lock.
8)
Disconnect two connectors on the left side of the side guide
upper.
9)
Remove the side guide upper.
(11) Side guide lower
1)
Remove the side guide upper. (See (10).)
2)
Remove the side guide lower.
NOTE: When assembling, place the polyester film (2 positions) on
each side of the side guide lower and attach.
[
1
]
[
1
]
[
2
]
Summary of Contents for MX-FN10
Page 52: ...Memo ...
Page 53: ...Memo ...
