Sharp MX-2300 G, Installation Manual

Page: 30 / 88

MX-2300/2700 N/G MX-RPX1 4 – 6
5) Close the RSPF unit, and loosen the hex nut of the RSPF
diagonal adjustment screw section.
Turn the hex wrench of the RSPF diagonal adjustment screw
to adjust the alignment.
* In the case of (A), turn the RSPF diagonal adjustment screw
counterclockwise.
In the case of (B), turn the RSPF diagonal adjustment screw
clockwise.
6) Make a copy again and measure (a) and (b) on the copied test
chart. Repeat procedures 2) to 5) until the condition ((a)-
(b)=
r
1mm or less) is satisfied.
F. Angle adjustment plate fixing
1) Lift the rear side of the machine and the angle adjustment
plate, and fix it with the screw.
G. Adjustment with the simulation
(1) SPF size width detection level adjustment
1) Go to SIM53-6.
2) Set the tray document guide to the max. width position, and
press [EXECUTE] key. The button is highlighted and the tray
size volume maximum value adjustment is started.
* During the adjustment, "EXECUTING..." is displayed.
* After completion of the tray size volume maximum value
adjustment, the set value is saved to EEPROM and RAM
and the display is shifted to the tray volume A4R size adjust-
ment value start screen. (Each set value is saved to
EEPROM and RAM at each setting.)
3) Set the tray document guide to A4R (11 x 8.5R) width position
and press [EXECUTE] button. The pressed button is high-
lighted and the tray A4R size adjustment is started.
4) Adjust the tray volume A5R (8.5 x 5 1/2R) size and the tray
size volume minimum value according to the above proce-
dures.
5) After completion of the adjustment, "COMPLETE" is displayed.
If the adjustment is not completed normally for any rea-
son,"ERROR"is displayed. In that case, the adjustment must
be executed again.
<Adjustment item and content>
When one of 1-4 in the above table is selected, the guide plate is
shifted to each position of the four widths of the guide plate shown
in the table below. The value of the document width sensor
(RSPF_WIDTH) A/D value is saved to EEPROM.
<Guide plate positions and widths on the mechanism and A/D
values to be saved>
[Initial screen]
3
1
2
A
B
No. Display Content
1 TRAYVOLMAX Tray size volume maximum value
2 TRAYVOLA4R Tray volume A4R size adjustment value
3 TRAYVOLA5R Tray volume A5R size adjustment
4 TRAYVOLMIN Tray size volume minimum value
No.
Guide plate
position
Widths on the mechanism A/D value,
code in
the figure
below
Remark
AB
series
INCHI
series
Code in the
figure below
1 Maximum
position 299 299 WIDTH_MAX AD_MAX
2 Middle
position (L) 210 215.9 WITH_P1 AD_P1 A4R OR
LTR
3 Middle
position (S) 148.5 139.7 WITH_P2 AD_P2 A5R OR
INVR
4 Minimum
position 118 118 WITH_MIN AD_MIN
0
SIMULATION NO.53-06
TEST
SPF TRAY ADJUSTMENT
CLOSE
EXECUTE
TRAYVOLMAX TRAY ADJUSTMENT.
PRESS [EXECUTE] TO START