LL-T1512W
2 – 4
2. INSTRUCTIONS FOR ATTACHING A VESA COMPLIANT ARM
An arm or stand based on the VESA standard (purchased separately)
can be attached to the monitor.
Procurement of the arm or stand is at the customer’s discretion.
Arms or stands able to be used
Attachments must satisfy the following.
• Compatible with the VESA standard
• Have a gap of 75 mm
u
75 mm between the screw holes on the sec-
tion to be attached
• Not be likely to fall off or break off after being attached to the moni-
tor.
How to attach the arm or stand
Notes: • Do not bend the signal cable or the AC adapter cable nor
place weight on them. Doing so could lead to damage.
• While following these instructions, please also refer to the
installation instructions in the operation manual included with
the arm or stand.
1. Turn off the monitor’s power and unplug AC plug from AC outlet.
2. Unplug AC cord from AC adapter’s AC inlet.
When you are faced with an AC cord tightened into AC adapter,
please pull off it slowly and carefully.
3. Remove the rear covers (a)(b)(c) in following the instructions given
in page 12.
4. Remove AC adapter from the stand.
1) Disconnect the plug from DC-IN connector.
2) Remove the cord from hook and the cord holder.
3) While lifting AC adapter’s cord root side, slide it toward the
round opening, and then pull toward you to remove AC
adapter.
5. Remove the four screws and then remove the stand from the mon-
itor.
Caution: • The stand is specially made for use with this monitor. Once
having removed the stand, never attempt to attach it to
another device.
• Once having removed the screws, store them together with
the stand and if the stand is ever re-attached be sure to
use the original screws. Using different screws could lead
to a malfunction.
6. Attach the arm or the stand to the monitor with four screws.
Caution: The screws used to attach the arm should be M4 screws
with a length of 4 mm ~ 6 mm protruding from the surface to
be attached.
Malfunction or may lead to the monitor falling off, internal
damage, personal injury.
7.
Attach the cover (a) according to the instruction given page 13.
Hook
Cord holder
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
4 ~ 6 mm
