Sharp LC-90Y8T, Service Manual

Page: 9 / 67

LC-90Y8T
2 – 4
Preparation
Attaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
•
Do not remove the stand from the TV unless using a wall mount bracket to mount it.
Before attaching the stand to the TV, build a work table
on which to rest the TV.
• To build the table, use the cushioning materials used in the
packaging.
TOP-C
FRONT
TOP-L
TOP-R
• Of the cushioning materials used, TOP-C is also used during
stand unit assembly. Be sure to assemble the stand unit
before building the work table.
Stand Unit Assembly
1
Confirm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
2 1
Set the post for the stand unit onto the TOP-C.
2
Attach the base to the post.
3
Insert and tighten the 8 screws into the 8 holes
on the bottom of the base.
• Hold the stand unit securely with one hand, and then
tighten the screws.
FRONT
1
1
2
3
Long
screws
Building the Work Table
3
Attach the joints and close the case.
1
Insert a joint into the hole on the side of the case.
2
Pressing the tab, fix the joint into place.
1
2
4
Insert each of the cushioning materials in the
respective directions shown in the figure.
• Insert TOP-L and TOP-R into the left and right sides of
the case respectively.
• Insert TOP-C to fit between the lines on the other side of
the case.
TOP-L
TOP-R
JOINT
CASE
LINE
TOP-C
5
The case is equipped with push-in tabs to hold
the cushioning materials in place. Push in the
tabs (2 for each location) to secure the cushioning
materials in the case.
Push-in tabs
6
After you have built the work table, spread a
blanket or similar soft cloth over the table and then
lay the TV display down on the covered table.
• Do not use a small table for this.
Attaching the Stand to the TV
7
Insert the stand into the openings on the bottom
of the TV.
• Make sure that the stand is firmly inserted into the TV.
Improper installation may result in tilting of the TV set.
8
Insert and tighten the 4 screws into the 4 holes on
the rear of the TV.
Short
screws
NOTE
• In the installation procedure, be careful not to catch your
fingers between the TV set and the floor.