E14
Connecting the monitor to a computer
CAUTION!
- When connecting, ensure that the monitor and
all the equipment you are connecting to it are
switched off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.
Notes:
- When using the monitor with an analog
connection, perform an automatic screen
adjustment (page E21) under the following
conditions:
- Using the monitor for the first time.
- After having changed the system settings
during use.
- When using the monitor with a digital
connection, automatic screen adjustment is
unnecessary.
- Depending on the computer or OS, you may
have to install the set-up information for the
monitor. (See page E37.)
- When connecting to a notebook and the
notebook computer's screen is set so that it is
displaying at the same time, the MS-DOS screen
may not be able to display properly. In this case,
change the settings so that only the monitor is
displaying.
Analog connection
Connect the supplied PC analog signal cable to
the analog RGB output terminal of the computer.
See page E8 for information on removing/
replacing the terminal cover.
- Paying attention to the connector direction, firmly
insert the signal cable straight into the
connector, and then tighten the screws at both
ends.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.
PC analog RGB input terminal
PC analog signal cable
(supplied)
Analog RGB
output terminal
Power Macintosh
Macintosh conversion adapter
IT-23M1U_gb_01.P65
2004/08/20, 10:41
14
